Wet-Room Floor Barrier Silicone Self-Adhesive – Premium, Easy to Install, 12mm Water Block, Ideal for Bathrooms, Showers, and Kitchens, 98in Length by Hzetuu

Super strong adhesive, nice thickened rubber and a very good seal given when attached. Simply peel off the red tape and then stick down - make sure you have it in the right place first, however - as it is a very strong adhesive to then remove... Should last a good while!

This floor barrier comes in a plastic pouch and inside you’ll find the barrier wrapped in a coil, a pair of disposable gloves, and an adhesion promoter. The coil is made from silicon and is shaped in a way that it can keep water inside an area it surrounds. The bottom of it is flat and has a double-sided adhesive strip along the entire length. The top side is flat for the most part and then it arches upwards to be able to keep any splashes inside the area as it will roll back down the ridge and back inside the area. The silicon is very flexible and can manipulated to go around things and not just in a straight line. I did find that if you need quite a sharp bend, heating it up with a hair dryer makes it go softer and it is easier to bend when it’s warm. We have a wet room where we take our showers, and water sometimes makes it over to the door. I used the silicon to create a barrier around the shower area and it’s doing a good job of keeping the water inside. It’s been down for nearly a week and is showing no signs of unsticking from the floor. I did put some silicon sealant against the barrier on the inside to make sure that no water could penetrate underneath it, and it seems to be working fine. This was so easy to place down as you just clean the floor, pull back some of the protective tape on the double-sided adhesive on the bottom, and then stick it down in place. Really easy to do and I had it done in ten minutes, included applying the silicon sealant…

This came as a roll with gloves and two sachets of adhesion promoter, be careful of these two sachets, as they can be harmful to the skin and should not be inhaled, I got mine in a white, it has a L shaped front, to hold the water in is 12mm wide and mine was just over 11ft long.The makers say this is 100% silicone and is very pliable and very easy to cut as well, I have put it around my toilet and it went on easily and stick down without having to add any more glue, though you can put some on if you like.I would say that this is a quality silicone tape, very well made and it does what it says, I only wished I got a longer amount, as I want to put some around my shower, this takes me to the price, I know this is good, but I recently also bought another brand, which was much cheaper and works just as well, so it is a bit expensive, as a result I am giving it a respectful four stars.

A well made silicone 3.5 metre long water dam strip. The bottom already has self adhesive. After removing old, cleaning off any remnants and other gunk under it, cut to length, peel, and adhere where choose on shower tray, floor tiles (wet rooms), bathtubs, and even on lino if have a leaky washer.I have a section on my shower tray and along end of bathtub, I replace annually. This keeps all looking fresh and clean. It does not take much height to stop shower from having to squeegee back onto shower tray for drain.This one is L shaped and very Soft to step on! With 3.5 metres, I have enough to do all my Wet zones.Freshen, brighten your bath or ensuite with a fresh water guard to dam off wet zone from dry zones.

I ordered this to replace the edging around my shower tray, but then had another idea while complaining about the draught coming through the bottom of the patio doors.I have utilised this stripping across the base of the UPVC doors with great success. The strip is sturdy and chunky, and has worked well to cover the huge gap between the doors and the carpet (see before and after photos). Easy to use, with 2 sachets of adhesive and a pair of protective gloves.Very pleased with the result. The strip blends in perfectly with the UPVC. I just need to buy another one now for the shower tray!

This was just the product I needed to finish off the new kitchen worktop and sink I fitted recently.It’s very easy to applyOnce you remove tape make sure you put it in the correct position as it’s very sticky but can lose the adhesion if you pull it up to move a littleThis method worked perfectly, and it was a breeze to apply to both the worktop and tiled splashback.

This has sorted out the problem I had with my shower door.I already use the plastic/silicone strips that you slide along the base of the door to seal against water drips from the shower but because of the way that my particular shower door was installed, there was a taller gap right at the hinge which the door-seal strips were never able to bridge and so I had a frustrating problem with water always leaking through that gap and onto the bathroom floor.This barrier strip was a doddle to use and I only needed a small piece so I have loads spare to replace with if the piece I used gets mouldy or manky.Easy to cut with ordinary kitchen scissors, you just peel off the red adhesive backing and stick in place. There is extra adhesive in sachets, provided if you need it, but I found it stuck down perfectly just with the onboard adhesive.Simple and effective 10/10