AbraFit Deadlift Barbell Jack Alternative Wedge, Safely Load and Unload Barbell and Plates, Multiple Colors

Good stop for you bar, use on a straight bar and hex bar. One side is angled so you can roll you weights on to it.

I wanted a single one of these to use when loading up one end of a barbell while the other swivels in a "landmine" device. I wasn't sure it would work when rolling a bar in an arc, as opposed to a straight line, but the arc turns out to be so slight when moving such a short distance that it works perfectly. It's purpose, of course, is to hold up one plate of any given size while other plates of the same size are loaded on or taken off, though I find that use less necessary, especially with 25s). If you put on a 25, then you can raise that 25 off the ground to make loading additional 25s easy. It works very well, weighs very little and takes up little space in my duffle.

Works great! Almost don’t even know they’re there, doesn’t slip and seems to be good quality. I can’t ask for anything more

Remember roll the weights on the the jacks one by one after or before use. Don’ t try to fit by dropping them on.

These are okay. I wish they were wider. I find myself bent over struggling to align these with my plates half the time.

just what I needed for me to help load the plates on the bar for deadlifts

It works!!

They work. Ramp could be more pronounced. It takes time and effort to get it on just right. You must align it on the inner most plate or you’re left doing a one arm barbell roe to slide the weights in place.