Fydun Shift Knob Boot Adapter, Gear Shift Knob Boot Retainer Adapter, Shift Knob Boot Retainer Nut Adapter Limiter Shifter Adapter Shifting Head Buckle Stopper Universal for Car (Black)

Does what it’s made for and looks smart. Doesn’t look out of place.

The top size could be a little smaller, I end up using a little filler to make it good for the touch, still recommend.

This review and images are off my Civic Sport 2017, fitting is easier than the instructions. Remove left and right trimming (not fully) and unscrew the two screws. Remove 4 wiring plugs and cut off cable tie on the inner boot lining. Inset the three grub screws to the product and position on the gear shift arm, add orange ‘o’ Ring. Place the gaiter over the product and push the leather around it, once in place turn inside out and secure with the orange ‘o’ Ring. Re-assemble the dash, done.

Good for putting a new gear knob on an old non-threaded gear stick

Fitted this to my Nissan 370Z after I put on a aftermarket shifter. The fitment is good and worked great for me.

I bought this to go with my skunk2 shift knob in my prelude. I was surprised by the quality as it has a good feel and isn't just cheap plastic. Unfortunately when I put it on there wasn't any room for the locking nut that came with the knob, and I wanted a bit more room between the knob and the collar since I didn't like the feel. I had to use a drill to make it bigger so that it would sit lower on the stem of the lever below the threads. I also didn't find the o ring that comes with it particularly useful as the vinyl boot in my car just slid down under it straight away, so a cable tie is recommended. But despite these small issues, it now fits and looks very smart.