Spal30103202 12" Puller Fan 12 Volt High Output Curved Blade 1870 cfm VA01-AP90/VLL-66A

89 K1500 Chevy removed mechanical fan and installed some cheap fans that would not cool. In the South it gets hot in the dog days of summer. First I bought SPAL 30100401 16" Pusher Fan 12 Volt Low Profile Straight Blade it worked ok but needed more while sitting still. So I bit the bullet and bought the SPAL 30103202 12" Puller Fan 12 Volt High Output Curved Blade. Man the air flow is awesome and no problems cooling while driving or sitting still with A/C running wide open. You will need a shroud and a stronger alternator I would recommend at least 260 high output if you like 80's rock and Led Light Bars. Save time and money and headaches. I have both Spals installed, you only need one running when its 65F or below have the big boy hooked up to a rocker switch that I can turn off or on. All from Amazon.

Works great very good air flow easy to install high quality fan . Recomend the purchase ofspall FR-PT-HO connector pigtail .

Fan works great but it comes with a special plug and that's great but there's no male plug so you have to cut the plug off so you can use it (how stupid is that)

Replaced some higher cfm rates Chinese junk with these. Omg do they move some air. Awesome. A bit thicker than I expected but amazing still

Works great!

The media could not be loaded. Pulls a lot of air through my condenser and uber thick handmade radiator. Had to make a “custom” shroud to attach it to, not the most beautiful craftsmanship but it gets the job done just fine! Keeps the A/C nice in traffic and on a 98° day can keep radiator coolant temps around 10° +\- ambient temps while idle, so it’s a large improvement over stock for sure. You can even feel the air pulling through the grill.Only con I have is that the first one I had ordered, the blades popped off. Turns out there is a little clip that attaches everything together. Looked like it was chewed up and gave out at some point as it’s all plastic? Regardless glad the blade tips are attached to a circle as a whole piece otherwise that would’ve destroyed $1,200 of Radiator if the tips slapped and bounced around on the fins!The replacement one works great after plenty of driving. Would recommend!

So my 2015 Subaru STI launch edition is a stage two built motor a aftermarket 2 inch radiator and was still having overheating issues so I purchased the meshemoto fan shroud and tried to use it. It work well, so I purchased two of these fans. 1870cfm They were broken, The packing is not very sturdy but still worked very well. I had to modify the.Moto fan shroud to make room for the fans to fit there is about an inch in between the back of the fan in the engine and it blows a lot of air. Be careful on the way you wire it up send signal backwards. I blew out a couple of fuses because I did not have thick enough wire.