6 pcs 3D Printer Switch Mechanical Limit Switch Module Micro Endstop Switches with 1m 3pin Cable for 3D Printers Parts Ramps 1.4

Switches are great, just note...when wiring these to a BTT Manta M8P (or other manta models), depinning/swapping the red and white wires on one end of the supplied cable is needed to avoid a "short". Plugging these in without rewiring will cause your board to immediately shutdown.Thanks, random other reviewer (BTT Octopus boards)!

These are a perfect replacement for my limit switches on my Sainsmart 3018Prover. The levers on the original ones kept falling out. I put a small drop of epoxy on the new switch levers to keep them in place. Now I use the original levers as spares (which I haven't had to use yet).

Work well, Minimal intrusion into the work area (used on 3018 CNC). Wires more than long enough for my application. Had to change the plug on one end to interface with my control board (no problem here). Good product.

When plugging it into my BTT Octopus Pro, the included cable heats up really fast. After reading a review on another switch from R REIFENG, I switched the red and white wires. Works now and doesn't heat up the cable.

Genial producto, el cable es ve bastante resistente y duradero, igual los interruptores. Todos funcionan muy bien.

lever has broken off half of them, can only 3 as homing switches, too wide to use limit switches

works with my zonesstar but pins have to swapped. This is normal when you change brands of switches.